Quick Answer: How Much Does It Cost To Get 4.10 Gears Installed?

What are 4.10 gears good for?

A 4.10 axle ratio will provide improved acceleration in stop and go city traffic.

A lower gear (higher numerical) ratio provides more low-speed wheel torque, which makes it easier to get the vehicle moving when pulling a trailer or carrying a heavy load..

Do 4.10 gears make a difference?

Installing 4.10 gears improves the car’s performance on the track but with negligible effects to the highway driving. … Switching from a gear set of 3.55 or 3.73 to 4.10 gears will affect your gas mileage slightly as your engine will be turning more times to rotate the rear wheels once.

Are 3.73 or 4.10 gears better?

Vice versa, if the gear ratio is lower it has worse acceleration but a higher top speed. So, by changing your gear ratio, no power levels are being changed, just the torque….WHICH GEAR RATIO IS FOR YOU?3.73 RATIO4.10 RATIOBetter gas mileageWorse gas mileageHigher top speedLower top speed2 more rows•May 12, 2020

What gear ratio is best for speed?

A gear with a lower numerical ratio, like 3.08:1, does not multiply torque as much, but with an equal rpm input will produce a higher axle or tire speed, all else being equal. This means that rear gear ratios are a compromise.

Does 3.73 gears make a difference?

Yes, while it’s a noticeable improvement in seat of the pants acceleration, you will run out of rpms quicker with 3.73s. In the long run you’ll find yourself looking for more engine rpms. The increased torque multiplication of lower gears will help make better use of a higher revving engine combo.

How fast can you go with 4.10 gears?

If you do a lot of freeway daily driving that’s something to keep in mind because your fuel economy is going to be affected. Edit: I did the math, assuming your car is a 5 speed manual, with 4.10 gears 5th revs out at over 180 mph. So, you won’t loose any top speed.

How much does a gear swap cost?

Most gear installs cost around $150 to $200 for a good price not including the gears. Yours will be a little bit more since they are doing the bearings but as stated call around and see what you get for prices. When you start hearing $500 and $800 laugh in their face and walk away.

How much does it cost to change your gear ratio?

As to cost, depending on where it is done, it could cost you as little as 750 dollars to as much as 1500 dollars per axle. Best prices would probably be a performance shop that does it all the time.

How much does it cost to get Gears installed?

Dealers typically charge about $90-$95 per hour. Speed shops usually charge about $80-$120 per hour, so labor “should” be about $300-$400 for a properly installed gear set that’s done-right-the-first-time. Add in cost of parts, supplies, fluids, shims, bearings, etc.

How much does it cost to get a rear differential fixed?

Rear Differential Replacement Cost This will not come cheap. Even buying a high-quality used component that still has a solid warranty will cost between $1,500 and $2,000 once you have it installed. If you prefer a new rear differential, expect to pay closer to $3,000 to $4,000.

Does gear ratio affect horsepower?

Motor HP does not change when you change gear ratios. The only thing that changes is torque. A dynamometer measures torque and RPM, and from those two values calculates horsepower. When you change gear ratios both RPM and torque will change but horsepower will not.

How much does it cost to install rear end gears?

If new gears are needed the price can be at least $1,500. Going to the worst-case scenario, if the differential is beyond repair, you’ll need the component to be replaced altogether. You can expect a rear differential replacement to cost up to $4,000.

Can you replace gears in a transmission?

Replace one, or more, problematic gear synchros that are responsible for housing the individual gears in your transmission. These tend to wear down faster on manual transmission cars. … Consider replacing these components if they are diagnosed as being the culprits to help repair your gearbox.

How much is it to fix a rear end?

Complete Replacement. A typical rear differential repair costs anywhere between $200 and $400. These typical repairs would include your bearing, seals, and fluid changes. Of course, when a gear change is required, that’s when things get pricey. $1,500 is just the minimum you can expect to pay for new gears.

Are 3.73 gears good for highway?

Well, if you plan on doing a lot of freeway driving, you don’t want to choose a gear that’s too low for your car because you’ll be going down the freeway at too high of an RPM. … Shorter gears (higher numbers) are much better suited for accelerating, such as 3.55, 3.73, 3.91’s, 4.11’s etc.