# What Does PCD 100 Mean?

## Does pcd114 fit PCD 100?

No can do.

PCD 100 how to fit PCD 114.3.

cannot go in.

Look like you have to sell it off..

## What is the difference between PCD 100 and PCD 114?

So lets say you have an alloy with 4×100 PCD. It means it has four holes and the distance between one bolt hole and the one opposite to it is 100 mm. 5×114 is slightly different. It simple means the circumference on which all 5 holes are drilled, it has a diameter of 114 mm.

## How do you find PCD of three holes?

The easiest way calculate the PCD is as follows:Identify the size of rim or tyre size. … Measure the distance ‘S’ between two adjacent studs from the centre of each hole.Using the calculator enter the number of studs/holes & ‘S’ and press ‘calculate’.More items…•

## How do I check my PCD flange?

How Calculate PCD (Pitch Circle Diameter) of a Flange?As accurately as you can, measure two adjacent holes using a varniar scale and calculate the PCD; then calculate for-4 holes: multiply by 1.414.8 holes: multiply by 2.613.12 holes: multiply by 3.864.16 holes: multiply by 5.126.

## What does PCD mean in engineering?

Pitch Circle DiameterThe PCD of a flange is one of the critical dimensions. PCD (Pitch Circle Diameter) is the diameter of a circle that goes through each of the bolt holes.

## What is PCD of gear?

Pitch Circle Diameter (PCD) – Gear Terminology The center distance of two meshing gears is expressed as the sum of the pitch circle radii of the two gears. Since the module of the meshing gears are the same, center distance a = d₁ + d₂ = (z₁ m + z₂ m)/ 2. The pitch circle of a gear does not physically exist as a form.

## Are all 5 stud wheels the same?

Will any 5 stud wheel fit any other 5 stud vehicle? … No, you need to check bolt PCD and wheel offset. You may also need spigot rings, and the bolts need to be the same type (some bolt heads sit at different angles).

## What PCD means in Tire?

pitch circle diameterThe bolt circle’s measurement is determined by the bolt circle diameter (BCD), also called the pitch circle diameter (PCD). The bolt circle diameter is typically expressed in mm and accompanies the number of bolts in your vehicle’s bolt pattern designation. One example of a common bolt pattern is 5×100.

## Are all 4 stud wheels the same?

Not all 4 stud wheels are the same Pitch Circle Diameter (PCD) although a 100 PCD is most common. Use this wheel suppliers site and key in each of the two cars and you’ll that Acura wheels should mount on the Rio.

## What cars have a PCD of 5×112?

Audi – found 37.Bentley – found 6.BMW – found 19.Chery – found 1.Chrysler – found 1.Daewoo – found 1.Ford – found 3.Infiniti – found 2.More items…

## How do I find my PCD?

The P.C.D. of any wheel or hub with an even number of holes can be measured from the inside of one hole directly across to the outside of the hole opposite. To calculate the P.C.D. of a five stud wheel or hub, measure ‘X’ from the inside of one hole to the outside of the next hole and multiply by 1.7012.